Control Chief TM6000 Manuel de l'opérateur télécharger pdf (Page 86)

TM 10-3930-660-10

0006 00-16

OPERATION UNDER UNUSUAL CONDITIONS - CONTINUED 0006 00

EMERGENCY BOOM OPERATIONS - CONTINUED

f. Connect the union end of the tow hose to the emergency steer pump hose that was disconnected in step e.

g. Disconnect both hoses from the base ends of the boom hoist cylinders at the main control valve tee fitting (bot-

tom left port). Install caps on the main controls valve tee fitting.

h. Connect the tee end of the tow hose to the boom hoist cylinder rod hoses that were disconnected in step g.

NOTE

If the boom will not raise during step i, move the hydraulic joystick lever to the boom raise position.

i. To raise the boom, make sure the emergency steer switch is on. Turn the start-run control switch on until the load or

forks are about 24 in. (61 cm) from the ground. Turn the starter-run control switch off.

j. After raising the boom, reconnect the lines by reversing steps b through h and return fitting to the emergency lift/

retract kit and the towing hose to the dummy tee.

k. Install transmission cover.

REAR WINDOW EMERGENCY EXIT

The rear window can be used as an emergency exit when exit through the cab doors cannot be made. To open the

emergency exit, proceed as follows:

1. While facing rear windows, grasp tag attached to rubber locking strip.

2. Pull tag and rubber locking strip fully out from rubber molding of rear window.

3. Push outward on rear window to remove rear window from cab.

4. Exit cab through rear window opening.

END OF WORK PACKAGE

409-3012

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 200 201

Pas de commentaire

Control Chief TM6000 Manuel de l'opérateur Page 86